Router os v74/3/2023 ![]() ![]() In this useage of the term, a loopback interface is a “free floating” interface that never goes down. Technically, this step is optional, but it is definitely best practice to use a loopback and for the address of the loopback to be the same as the RouterID. In Winbox, navigate to IP -> Addresses and then add a new address: Here are the Order of Operations as I see them:ġ) Add all link IP address to their respective interfacesģ) Add the loopback interface IP address as wellħ) Create an Interface Template for each interface that is participatingĨ) Check the Neighbors and make sure that all neighbors are connected and in a full stateĩ) Check the Main Routing Table and make sure the correct routes are thereįor Example: the Gateway Router has 4 link IPs. If you need help setting those things up, please refer to one of the other tutorials. ![]() To shorten this article, we will assume that the most basic settings (internet connection, System ID, ect.) have already been configured. This tutorial is using a small WISP as the example, but it’s applicable to any basic OSPF setup. For example, OSPF IPv4 and IPv6 are now both configured in the same place (this tutorial will focus on IPv4). ![]() In ROSv7 there are both significant improvements and significant changes in the syntax to get OSPF working. ![]() ROSv7 – OSPF Basic Configuration Introduction ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |